How to Achieve the Best Decorative Concrete
If you want a beautiful addition to your property, you can add stamped concrete. However, if it is poorly done, it will turn out badly for you and the contractor as well. During the process of stamping, it is vital that there are no spots left unattended to because these issues will only be noticed after the process is all done. The best contractors have already learned from their mistakes and have seen all these scenarios. There are several tricks that will help achieve better texture and they are listed below. It is important to make sure that you stamp as early as possible. If you are able to start the stamping early, it is easier to because all you will be required to do is walk on the stamps.
The other thing you could do is reduce the evaporation by setting the retarders. It is possible to assume that the slab has already become hard enough just because you can see that it has crusted. However, once you start stamping on the surface, you will realize that you are sinking because the crust is cracking. The reason why you apply the evaporation retarder is so that the surface dries well. The slab is going to be properly textured once you apply the retarder which usually slows down the evaporation.
The next thing you need to do is make sure that the slab is crawled. Just before you start with the stamping, you will need to send people out on kneeboards. The surface is going to be worked up because of the weight as well as the vigorous floating of the slab. This will make sure that the slab has the same consistency and stamping becomes easier. You will easily get the results you want this way. If the slab starts to get ahead of you, you can always save the situation by rolling the surface. Texture is easily gotten like this.
You can wear textured shoes as great tools for you to stamp the slab. These shoes are held into place by friction and the best part is that you do not have to deal with any straps or buckles. Since the weight of the wearer is over a large area, they will be able to walk on the concrete without sinking. Starting in the middle moving out is the best way to approach the stamping situation. Uniformity is what will be achieved by this technique and you will have consistent textures on the opposite ends of the slab. You will get the consistency you want but only if you use more stamps than usual and this is the one thing you need to note about this technique.